Documentation Comments
Use this form to comment on this topic. You can also provide any general observations about the Online Documentation, or request that additional information be added in a future release.
Reality V15.0 ()
T-VERIFY (Tape) (m604909+tverify.htm)
Compares two tapes and reports any data mismatches.
TCL-I command.
T-VERIFY channelA channelB
channelA/B Channel assignments previously made using ASSIGN, specifying the units containing the tapes to be compared.
Before using T-VERIFY, you must use ASSIGN to attach the required tape units to the port and give them channel letters.
T-VERIFY should be run after a T-COPY to check that the copy was successful. It ignores the date and time in the tape label as this is updated by T-COPY.
If multiple reels are verified, take care to load them in the correct sequence.
RECORD SIZE MISMATCH
[30000] TAPES DO NOT VERIFY
Two different tapes, or tapes that are out of sequence, are being verified.
BYTE MISMATCH
[30000] TAPES DO NOT VERIFY
The copied tape contains an error.
T-VERIFY A B
If the copied tape contains an error:
BYTE MISMATCH
[30000] TAPES DO NOT VERIFY
If the copy is correct:
[30001] TAPES VERIFY