Documentation Comments

Use this form to comment on this topic. You can also provide any general observations about the Online Documentation, or request that additional information be added in a future release.

Reality V15.0 ()

Example Session (REMLOG) (m603003+example.htm)

To	Reality
Version
Topic
Submitted by
Company
Location
Email address
Comment

Example Session

The following is an example of using REMLOG to access a Reality environment from a UNIX system.

Notes:

Before using REMLOG, the terminal type must have been set up correctly.
Key combinations that are not echoed on the display are shown enclosed in chevrons. For example, <CTRL+]> means that the user held down the CTRL key and pressed ], but this was not echoed to the display.

$ remlog

remlog> help

Command list :
help or ?             print help information
open or connect       open a connection to a remote host (open|connect host)
close or disconnect   close the connection
status                print status information
set                   set operating parameters (set parameter value)
remote                go to remote mode if a connection exists
!                     escape to the shell
exit or quit          exit or quit remlog
remlog> status 
No connection
Parameters:
     ESCAPE: CTRL ]
     TRANSLATE: YES
remlog> set TRANSLATE NO remlog> remote No connection present
 remlog> connect Reality1 Connecting to 'Reality1'
Escape sequence to local mode is CTRL ]
Reality 1
LOGON PLEASE: SYSPROG Password: KEY1 :CT ROUTE-FILE SYS0     SYS0
001 M
002 
003
004
005
006
007
008
:CTRL+]

remlog> status Connected to 'Reality1'
Connection established at Wed Jul 17 16:01:03 1993
Parameters:
     ESCAPE: CTRL ]
     TRANSLATE: NO
remlog> remote  Escape sequence to local mode is CTRL ]
:CT ROUTE-FILE SYSO
SYSO
001 M
002 
003
004
005
006
007
008
:WHO 132 SYSPROG (Reality1,ODESSA)
:CTRL+]

remlog> disconnect remlog> status No connection
Parameters:
     ESCAPE: CTRL ]
     TRANSLATE: NO
remlog> quit