Documentation Comments
Use this form to comment on this topic. You can also provide any general observations about the Online Documentation, or request that additional information be added in a future release.
Reality V15.2 Online Documentation (MoTW) Revision 3
T command (DataBasic debugger) (m618706+t.htm)
Used with a variable name, specifies that the value of that variable should be displayed each time the program stops and enters the debugger.
Without a variable name, toggles whether the trace table is displayed on re-entry to debug.
T{ variableName}
variableName Specifies the variable to be traced. The named variable and its value will be displayed at each breakpoint.
A blank must be present between T and variable-name.
If variableName is omitted, the T command toggles the display of the trace table on re-entry to debug (default: on). The new state (On or Off) is displayed.
The values of the traced variables are shown in character format. The X command allows you to display the values in hexadecimal.
To display break points and traced variables, use the D command.
To delete a variable from the trace table, use the U command.
:DEBUG TEST HIWRLD D HIWRLD 1 *L* 1 > *VERSION 0001 2 HW = "HELLO WORLD" 3 PRINT HW 4 STOP 5 *T HW+ *E1 *G E HIWRLD 2 HW*G E HIWRLD 3 HW HELLO WORLD *X HW 48 45 4C 4C 4F 20 57 4F 52 4C 44 = *T Off *G HELLO WORLD E HIWRLD 4 *G :