Installation

This topic describes how to install the Standard Network Interface on your PC.

Installation Procedure

The PCSNI installation procedure creates a directory for PCSNI and then copies the software into it. To install PCSNI, do the following:

1. Insert the RealLink for Windows CD into your CD drive.

2. Select Run from the Start menu and enter the following command:

   drive:\PCSNI\SETUP

   where drive is the letter of the drive containing the RealLink for Windows CD. When a welcome message appears, click OK.

3. When asked which elements you want to install, check that SNI WinSock is selected and click OK.

4. If you are replacing PCSNI version 2.1 or later, you will be asked if you want to overwrite your WINSNI.INI configuration file. You should normally answer No to this question.

   Click OK to continue the installation.

5. When the PCSNI setup completes, click Start | Run again and enter the following command:

   "drive:\WinSNI Configuration Editor\SETUP"

6. Follow the instructions on the screen.

When the WinSNI Configuration Editor setup completes, remove the RealLink for Windows CD from the drive.