Documentation Comments
Use this form to comment on this topic. You can also provide any general observations about the Online Documentation, or request that additional information be added in a future release.
Reality V15.2 Online Documentation (MoTW) Revision 3
Editing a Network Printer Entry (UNIX-Connect Administration) (m603103+edit.htm)
To edit a network printer entry, select
editnetprinter
from the
Network Printer Administration menu. You will see the following
prompts:
Do you wish to edit a
Reality Release 4.x network printer [y/n]:
y.n and go to
step 3 below.REALROOT not set.
REALROOT [absolute path]:
This prompt is only displayed if the environment variable REALROOT is not set. Enter the absolute pathname for REALROOT (refer to your Reality documentation for details).
A list of network printers is then displayed:
The following network printers are currently installed: name name name Enter the network printer you wish to edit:
Enter the name of the network printer entry that you wish to edit.
On entry of a valid name, the following message is displayed:
To leave a parameter unchanged, enter <return> at the
appropriate prompt
This is followed by messages each giving a current parameter setting and followed by a prompt to enable an alternative setting to be entered. Press RETURN in response to a prompt to leave the current setting unaltered. See Printer Configuration for details of the prompts and valid responses to them.