Documentation Comments
Use this form to comment on this topic. You can also provide any general observations about the Online Documentation, or request that additional information be added in a future release.
RealityV15.1Online Documentation (MoTW) Revision 7
LOAD-IMAGE (MOUNTIMAGE.HTM)
MOUNT-IMAGE
Mounts a physical backup of a
database and enables it to be accessed in read-only format.
Syntax
MOUNT-IMAGE
Restrictions
- MOUNT-IMAGE is only available in the SYSMAN account.
- MOUNT-IMAGE may only be run by the database
owner.
- A physical save cannot be restored on a host with different byte ordering;
for example, a SAVE-IMAGE save of a Windows (Intel) database can be restored on
a Linux (Intel) system, but not on a Solaris (SPARC) system.
-
MOUNT-IMAGE does not support encrypted tape drives.
-
MOUNT-IMAGE does not support ‘raw mode’ saves.
-
Although MOUNT-IMAGE could be used with an actual tape drive, for performance reasons it is only useful to use it with tape images.
Comments
- MOUNT-IMAGE enables an image save of a database to be mounted and accessed as if it were a live database (but read-only), thus enabling files and items to be accessed remotely. A skeleton database needs to be created, and you must supply a path and name for this database (defaults can be used). You must then supply a list of tape unit numbers, or paths, to tape images the database was saved to.
- MOUNT-IMAGE will create remote account pointers to any accounts you specify. These are standard R-pointers and can be created later if preferred. You must then manually create Q-pointers to the files you wish to access.
Note: When entering tape units/paths or account names, you can enter a comma-separated list up to the length of the input field to make entry faster.
Procedure
- Ensure that the tape is loaded and on-line, and you are logged on to SYSMAN.
-
Enter at the TCL prompt:
MOUNT-IMAGE
The following screen is displayed:
Mount Image Main Menu
1. Mountpoint Name = @_16.0
2. Mountpoint Path = C:/Cora/Dbase
3. Add Tape Units/Paths =
4. Account Prefix = @_
5. Add Accounts to Mount =
Account Mount As
======= ========
6. Delete Account 7. Delete Tape
Enter option, ?:help, m:mount image, a:abort :
- Leave options 1 and 2 unchanged or change them as required. (Default values come from the skeleton database, as created by mkdbase –m or realload –I commands.)
- Add the tape drives required on line 3 - i.e. tape unit numbers or paths to the tape images. If using tape paths and the line overflows, press RETURN and then use option 3 to add another drive.
- If you want any remote account (R-pointers) created, enter the account name(s) on line 4.
- If you have made a mistake, use options 6 or 7 to delete any account or tape drive.
- When you are ready, enter m to mount the image.
- Enter x to exit the menu.
- Create any Q-pointers required to access files in the remote accounts.
See Also
realload host command,
LOAD-IMAGE, SAVE-IMAGE,
realdump host command.